This program is an SMTP Client example. It shows you how to send 
a dynamic email to an email address. This example will configure 
the LAN network parameters for the evaluation board automatically
if a DHCP Server is available in your LAN.

If you do not have a DHCP server, you need to configure
the IP address, net mask and default gateway and Primary DNS
and Secondary DNS Server manually in the Net_Config.c configuration
file. You have to disable also 'Dynamic Host Configuration' under 
the 'Ethernet Network Interface' section.

WARNING!!!

You need to modify SMTP_uif.c user interface module and enter:
 - sender email address,
 - recipient email address 
 - email subject

and optionally for external SMTP authentication:
 - SMTP username
 - SMTP password

Modify also the SMTP_demo.c and enter:
 - SMTP server IP address

Sent email will have about 40 kBytes.

The SMTP_demo example is configured for Keil MCB4300 Board and is
available for several targets:

LPC4357 Flash:
    Program code is loaded into internal flash.

LPC4357 Flash Debug:
    Standalone Debug application.
    Program code is loaded into internal flash.
    
    Debug level configured in Net_Debug.c debug configuration file.
    Connect a serial cable to RS232 COM port to view
    output messages using HyperTerminal at 115200 baud,
    8-bits, no parity, 1 stop bit, XON/XOFF.

LPC4350 Ext. Flash:
    Program code is loaded into external NOR flash.


Jumper settings:
  J13 and J16 must connect pins 2 and 3
  to select and enable serial output on UART0/3 connector.
