This is a FTP Server example. It allows you to manage files
on SD Card from PC using FTP client.

Use this example to connect MCB4300 Board to a LAN with DHCP
server (most LANs have this). This example will configure the 
LAN network parameters automatically using a DHCP protocol.

If a DHCP server is not available, you may connect MCB4300
Board to PC directly over a crosslink network cable. In this
case configure a PC to use a static IP address 192.168.0.1 and
disable the 'Dynamic Host Configuration' in Net_Config.c
configuration file. The default static IP address of
MCB4300 is then 192.168.0.100

To test this example, open your ftp client and enter the
address ftp://mcb4300/ or ftp://<boards IP address>

Default user    : admin
Default password: <none>

The FTP_demo example is configured for Keil MCB4300 Board and is
available for several targets:

LPC4357 Flash:
    Program code is loaded into internal flash.

LPC4357 Flash Debug:
    Standalone Debug application.
    Program code is loaded into internal flash.
    
    Debug level configured in Net_Debug.c debug configuration file.
    Connect a serial cable to RS232 COM port to view
    output messages using HyperTerminal at 115200 baud,
    8-bits, no parity, 1 stop bit, XON/XOFF.

LPC4350 Ext. Flash:
    Program code is loaded into external NOR flash.


Jumper settings:
  J13 and J16 must connect pins 2 and 3
  to select and enable serial output on UART0/3 connector.
